Belt conveyor is one of the important supporting equipment of concrete block machine. Because of its simple structure, convenient use, easy maintenance, large transportation capacity, etc., it is also widely used in various industrial and mining enterprises. Concrete block machine supporting belt conveyor The work is mainly used for aggregate conveying, so it will be in an environment with more serious dust and sand for a long time, so it is more prone to various failures.
Keeping the belt conveyor of the concrete block machine in good working condition is also an important way to extend the service life of the concrete block machine and its supporting equipment, and it is also an effective way to improve production efficiency. The engineers of HGMA Machinery Company will help you analyze and analyze Solve the main reasons and solutions for belt slippage of the belt conveyor of the concrete block machine.
Note: When the equipment is running, it should be higher than 95% of the drum speed under normal conditions. If the friction between the conveyor belt and the drum is not enough, there will be slipping.
The main reasons for belt slippage of conveyor:
1. The belt tension of the conveyor is insufficient, resulting in insufficient frictional power between the conveyor belt and the drum, which makes it difficult to overcome the belt resistance, resulting in slipping;
2. The conveyor belt load is too high, exceeding the designed capacity, causing the belt to fail to operate normally;
3. The material being conveyed by the conveyor contains too much water, and the equipment is exposed to water, resulting in reduced friction and slippage;
4. Insufficient design of the friction coefficient between the conveyor belt and the roller causes the belt to slip.
5. Foreign matter (large pieces of material or waste roller debris, etc.) jams the belt of the conveyor, making the belt unable to run and causing slipping.
The main measures to deal with the belt slippage of the conveyor:
1. The tensioning device is used to increase the tension, but the amount of addition is limited, so that the belt does not bear excessive tension;
2. Use double rollers or multiple rollers to increase the wrapping angle so that it is always within a reasonable range;
3. Improve the coefficient of friction, ensure the scientificity of the coefficient of friction, and use wear-resistant materials.

4. Shut down in time to clean up foreign objects.